In cases where the factory sensitivity settings do not suit (site features, non-standard installation options, etc.), it is now possible to adjust the sensitivity by the user himself. To do this, switch the detector to the service mode and select one of the 15 sensitivity levels, which will be stored in the non-volatile memory of the detector.
To enter service mode, remove the battery and install both jumpers. Install the battery. Remove both jumpers before 10 seconds. The LED will start flashing, and the number of pulses will correspond to the sensitivity threshold level number. To increase sensitivity, set the upper jumper for a few seconds and remove it, and to lower it, set the lower one. The number of LED blinking pulses will correspond to the new sensitivity value. Set the desired sensitivity level and remove the battery. The new threshold level has been saved.
This feature has been implemented since June 2018 in the detectors "SPLAV L50RA", "SPLAV L70RA", "SPLAV V0RA", "SPLAV V10mini", "SPLAV L50GSM" and "SPLAV L70GSM".
The service mode in the ACCEL RA SPLAV and ACCEL GSM SPLAV vibration detectors allows you to select one of 15 operating modes (3 algorithms with 5 sensitivity levels) using the button on the case. The button itself can be turned off - then the detector can only be stopped by turning off the power.
